JHM Solid Linkage Upgrade for B6-B7 A4, 2004 and up (6-speed) - JHM-LNK-B6B7A46S

PROUDLY DESIGNED AND BUILT IN CALIFORNIA

NOTE: This linkage fits ONLY 2004 - on B6/B7 A4 6-speeds

If you desire the ultimate in shifting, the JH Motorsports B6/B7 A4 Solid Linkage Upgrade is the perfect solution. This linkage upgrade replaces the OEM rubber/plastic socket assembly with a steel spherical bearing (similar to what the JHM Solid Shifter does for the OEM shifter box). This will give you a full mechanical race car feel, and eliminates sloppiness allowing you to optimize shifts on the street or at the track. The linkage is most purposeful when used with the JHM Solid Shifter and the JHM Delrin Shifter Stabilizer Bushing, however these parts will compliment any SS kit, including stock shifters.

To completely upgrade your stock shifting components for the best possible shifts, make sure to add our Solid Short Throw Shifter and the Solid Stabilizer Bushing to your order if you do not already have them.

INCLUDES THE FOLLOWING - JHM shift shaft link (reuse your stock boot), JHM Modified Steel Spherical bearing, stainless steel spacers, all hardware, loctite and synthetic grease.

(This linkage is located at the transmission and is separate from our shifter) This linkage fits all B6/B7 A4 6-speeds, 2004 and On. The removal of the linkage rod is not too bad on the 1.8t and the 2.0t since it is located on the drivers side (Opposite side of where the downpipe is).

COMES AS A COMPLETE DO IT YOURSELF KIT Cutting is required to allow proper clearance.

VIEW COMPARISON VIDEO -->HERE


NOTE: This video was done on a B5 S4 which has the same basic design and works in the same fashion, the B6/B7 A4 linkage just looks a little different and has a shorter cross rod.

VIEW INSTALLATION INSTRUCTIONS -->HERE



NOTE: These instructions only cover the installation of only the actual kit once the linkage rod is removed from the car.

VIEW INFORMATIONAL VIDEO ABOUT THE LINKAGE ON CARS EQUIPPED WITH A 6 SPEED -->HERE


NOTE: This video helps you have a better understanding of the linkage and how this shift rod would be removed for replacement. However, this video was done on a B5 S4 which has the same basic design and works in the same fashion, the B6/B7 A4 linkage just looks a little different and has a shorter cross rod.

PICTURE OF THE JHM LINKAGE UPGRADE FULLY ASSEMBLED -->HERE

NOTE: Some cutting of your OEM linkage rod is required, other than that, this is a full bolt in kit.

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.