WARNING: This product can expose you to chemicals that are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.This does not fit the 306bhp model
- Washable and reusable design filter.
- Layered multi-density foam technology.
- Designed and manufactured in Great Britain.
- Improvement in engine power and torque
- Superior engine protection from dirt and dust ingress.
- Designed to flow stronger for longer.
This induction kit has been developed to fit Mini (Generation 3) vehicles fitted with a Bosch intake sensor part Number: 0 281 006 597 and the BMW 118i Before purchasing this item please use the photo guide below to correctly identify the intake sensor fitted to your vehicle.
Forge Motorsport have been at the forefront of Mini tuning since 2006, and proud sponsor of the Mini Challenge which sees our performance parts fitted to both the R56 and F56 generations of Mini, across the entire grid. The intake itself features a bespoke aluminium heat shield, which doubles as a scoop to direct air from the cold air inlet on the slam panel, and it picks up on the stock mounting locations with rubber grommets to reduce vibration and noise.
Compliment your Forge Motorsport induction kit with the mandrel bent high flow turbo intake pipe FMHFIP1 which eliminates flow restrictions associated with the OEM plastic pipe and resonator.
Take a look at our video to see the dyno test results and an impressive 10 BHP gain. The pipe to the filter is hand fabricated and features a precision machined MAF boss so that the cars original MAF can simply be bolted on to the new intake whilst the filter is manufactured to Forge’s specifications by Pipercross.
Finally, the intake scoop and hard pipe are finished in hard-wearing crackle black powder coat to give an OEM style finish. Fitting is very straightforward, requires no cutting or modification to the vehicle so it can easily be removed if needs be, and can be completed in 20-30 minutes. A replacement filter for this kit can be found here.
If you have the below sensor, this part will fit your vehicle.
.jpg)
*Please note - the Pipercross filter is excluded from the Forge lifetime warranty*
DO NOT OVER TIGHTEN
When fitting the filter to its counterpart please ensure you do not over tighten the hose clamp connecting them. Doing so could result in the part being crushed, leading to fitment and/or performance issues. The recommended torque setting for this hose clamp is 2-2.4Nm
- PDP tag:
- Free Shipping*
