WARNING: This product can expose you to chemicals that are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.A complete set will consist of left and right headers, with heat shield covers.
\nThese High Performance Headers were designed for the 430 Scuderia and 16M and are completely made from 1.4828 (T309 (1.4828)) grade stainless steel.
\nThe 4-2-1 design of these headers maximizes torque and horsepower in the midrange of the power envelope, right where the driver needs it. The bends and connection points are of a constant radius design which maximizes the exhaust gas flow. These headers are built as light and durable as possible.
\nThese hight performance headers bring a noticeable increase in power and torque. Since they are compatible with the original catalytic converters, the headers can also be used as a cost-effective substitute for defective OEM headers.
\nThe headers come standard with the new innovative CAPRISTO Heat Shield. The Heat Shields are made from a very high-heat resistant material, initially developed and used by NASA. This helps to reduce radiant heat from the exhaust headers and sports catalysts. The shields are heat resistant for temperatures of up to 1300 degrees Celsuis.
\nReduced heat or temperatures in the engine compartment improves performance. Cooler air boxes results in a cooler air temperature for the engine to "breath-in". In turn, the denser air makes more horsepower.
\nAs the outside of the glaring hot exhaust is shielded from its surroundings, the shields also reduces the possibility of fire which sometimes arises from liquids/oil getting in contact with the exhaust system.
\nThe heat shields can also be attached to the headers later on without dismantling.
\nThe Headers CANNOT be installed & used WITHOUT these Heat Shields.
\nShould you wish to retain the original OEM Exhaust (silencer), you must replace the exhaust mountings and brackets with the CAPRISTO mounting kit.
\nNOTE TO INSTALLER:
\nIt is important to note that these headers should not be torqued over 24 Nm or 17.5 foot pounds.
\nOver tightening will lead to stud failure and/or cylinder head damage.
- PDP tag:
- Free Shipping*
